Grundfos Low-Level Float Switch for CU-200 Only

Grundfos Low-Level Float Switch for CU-200 Controller

NOTE: The float switch does not come with a weight.

This is for the CU-200 Grundfos Pump Controller or other pump controller that uses solid state switching (that is, NOT in line with main AC power). Sensor float switches are used for low current devices such as magnetic contactors or pump control panels. The GF-100 is a low cost, three wire sensor float switch and is normally open in the down position. It is a mechanical activated switch and is NSF approved for potable water. If used with a SunPumps PC-Series controller it can be either a Pump-Up or a Pump-Down switch because the controller has a logic reversing circuit allowing easy logic change for any desired application. If used with the Grundfos CU-200 controller, it becomes a Pump-Up switch. It will turn the pump off when the tank is full. Maximum power rating: 5 Amps 125/250 VAC 50/60 Hz. This is a 3-wire switch, green/yellow stripe is ground. (Shown with optional pivot weight, not included.)